User's Manual

mode, all videos are saved at the same time. The indicator stops blinking and turns
into solid green.
 Important Tag
During the video recording process, press the Wifi/Important Tag Button, when you
hear three beeps, it means the current video is marked as important. When viewing
the local files, the video will be embedded with an "important" watermark.
 Reset
In the standby mode, if the system crashes, or the operation fails to respond, press the
reset button with a Sim-ejector to force shutdown.
 Insufficient Storage Notification
During the recording process, when the memory card capacity is insufficient, the
Badge Camera will beep three times once every 10 seconds until the storage is full
and stop recording. If loop recording is on, there will be no notification.
 Charging
When the battery power is low, the Badge Camera will beep twice once every 10
seconds until it is turned off. You can connect the Badge Camera to the power adapter
through the Type C interface to charge it. When charging, the red indicator lights up.
When the red light is off, it indicates that the battery is fully charged.
Note: Please be sure to use the power adapter provided with the camera to charge the
battery, otherwise it may cause damage.
 PC connection
Use the standard data line to connect the Badge Camera to the PC through the Type
C interface, the Badge Camera will enter into the disk mode by default, and the user
can view, download or format the data on the PC.
Note: When formatting the Badge Camera on a PC, please select the "default" format
- 5 -