User's Manual

Direct dialing

1. In the stand by mode, you have the following direct dial options: redial the

last number called by pressing the REDIAL button, retrieve from the

two-touch dial memory or retrieve from the caller list.

• If you press the wrong button when dialing the number, press the ERASE

button momentarily to clear the last entered digit.

2. Press the CID button to start dialing the number on the display. For

information on the different dialing methods. See Section "Using THE

REDIAL BUTTON" on page 21, Section "TWO-TOUCH MEMORY SPEED

DIALING" .on page 33 or Section "DIALING FROM CALLER LIST"

on page 40.

NOTE:

The following actions will clear the displayed number:

1. No operation is performed for more than 30 seconds after entering the

number.

2. The TALK button is pressed.

3. The ERASE button is held down for more than 2 seconds.

Setting the receiver volume

You can set the handset receiver volume to one of three levels: Normal (the

default setting), Mid or High. The volume control can be set only in the TALK

mode.

1. In the talk mode, press the

or button. Each press of the buttons

changes the display as shown below.

3050manual 21-34.P65 2002-5-31, 9:2622