User's Manual

13
WALL MOUNT INSTALLATION
Base unit may be mounted on a standard wall plate or onto two screws (not
included) that you fasten to the wall.
1. In case of using the standard wall plate, this step is not necessary. Place
the DESK/WALLbracket on the wall and mark the location of the screws.
Install the screws, leaving 3/16" extending out from the wall. Use anchors to
secure the screws.
2. To connect the DESK/WALL mount bracket in the desk/table position, align
the bracket with the slots on the base (as shown in this first illustration), until
it is securely in place.
3. Plug theAC adaptor into the back of the base unit.
4. Plug one end of the short line cord into the back of the base unit, passing the
line cord through the groove.
5. Plug the other end of the line cord into the telephone wall jack.
6. Mount the base on the wall plate studs and gently press until the unit locks in
place.
7. Plug theAC adaptor directly into the standard 120V outlet.
3050manual 2-20.P65 2002-5-31, 9:2413