User's Manual

1. BASE UNIT is plugged into power source.
2. HANDSET is charged.
3. TONE/PULSE switch is in the right position.
4. TELEPHONE LINE CORD is plugged into the TELEPHONE JACK and
TELEPHONE LINE CONNECTION JACK.
1. BASE UNIT is centrally located in your residence.
2. BASE UNIT is not located near appliances.
TELEPHONE LINE CORDS plugs are connected to the TELEPHONE JACK
and TELEPHONE LINE CONNECTION JACK.
If you had a power failure or had unplugged the BASE UNIT, replace the
HANDSET on the BASE UNIT for 2 to 5 seconds to reset the system.
1. BATTERY PACK in HANDSET is fully charged.
2. HANDSET is not too far from the BASE UNIT.
Noise may be picked up from electrical products in the home or electrical
storms. Generally, this noise is a minor annoyance and should not be
interpreted as a defect in your system.
Choose an alternate channel using the CH button on the HANDSET.
1.If you had a power failure or had unplugged the BASE UNIT, replace the
HANDSET on the BASE UNIT for 2 to 5 seconds to reset the system.
2.BASE UNIT is plugged into the power source.
Technical Information
Noise
Range
Interference
NOTICE:
This cordless telephone uses radio frequencies to allow mobility. There are
certain difficulties in using radio frequencies with a cordless telephone. While
these are normal, the following could affect the operation of your system.
Electrical pulse noise is present in most homes at one time or another. This
noise is most intense during electrical storms. Certain kinds of electrical
equipment such as light dimmers, fluorescent bulbs, motors, and fans also
generate noise pulses. Because radio frequencies are susceptible to these
noise pulses, you may occasionally hear them in your HANDSET. Generally
they are a minor annoyance and should bot be interpreted as a defect in your
system.
Because radio frequency is used, the location of the BASE UNIT can affect
operating range. Try several locations in your home or business and pick the
one that gives you the clearest signal to the HANDSET.
Electronic circuits activate a relay to connect the cordless telephone to your
telephone line. These electronic circuits operate in the radio frequency
spectrum. While several protection circuits are used to prevent unwanted
signals, there may be periods when these unwanted signals enter the BASE
UNIT. You may hear clicks or hear the relay activate while you are not using the
HANDSET. If the interference occurs frequently, it can be minimized or
eliminated by lowering the height of your BASE UNIT ANTENNA or by
relocating the BASE UNIT . You can check for interference before selecting the
final BASE UNIT location by plugging in the phone.
This cordless telephone uses radio communication between the HANDSET
and the BASE UNIT and may not ensure privacy of communication. Other
devices, including other cordless telephones, may interference with the
operation of this cordless telephone or cause noise during operation. Units not
containing coded access may be accessed by other radio communication
systems. Cordless telephones must not cause interference to any licensed
radio service.
Problem Solving Technical Information
12
13
Phone does not work, check the following:
Range of phone limited, check the following:
No dial tone, check the following:
Received signal flutters of fades, check the following:
Interference on reception, check the following:
If after pressing the TALK button, you receive three
beeps and no dial tone, check the following:
1.
2.