User's Manual

Before you can use your cordless telephone, you must charge the
HANDSET for 12 hours. Failure to do so will require recharging of the
BATTERY PACK more often.
Place the HANDSET on the BASE UNIT for 12 hours.
After 12 hours, remove the HANDSET from the BASE UNIT.
When the phone rings, lift the HANDSET. The IN USE indicator will light.
(Note: The HANDSET RINGER Switch must be in the "ON" position for
ringer to operate.)
Start your conversation.
To end your conversation, either press the TALK button or place the
HANDSET on the BASE UNIT. If you place the HANDSET on the BASE
UNIT charge cradle, you activate the automatic STANDBY feature.
When the phone rings, press the any button to answer the call. The IN
USE indicator will light.
Start your conversation.
To end your conversation, either press the TALK button or place the
HANDSET on the BASE UNIT. If the HANDSET is placed on the BASE
UNIT charge cradle, the automatic STANDBY feature is then activated.
Press the TALK button. The IN USE indicator will light up.
Listen for a dial tone.
Dial the phone number.
When finished with your call, press the TALK button again. The IN USE
indicator will turn off.
If you get a busy tone, press the TALK button to hang up.
Press the TALK button again.
Listen for a dial tone.
Press the REDIAL button. This will automatically redial the last telephone
number called.
Be sure the BASE UNIT IN USE indicator is off and the HANDSET is in
STANDBY mode.
Press the MEM button.
Dial the number you want to store.
Press the MEM button again.
Dial the index number (0-9) where you want to store that number.
You will hear one confirmation "beep".
Write the name of the person you will be calling with that number next to
the corresponding index number on the Telephone Number Label.
Repeat steps 1 through 6 for other telephone numbers. EXAMPLE: To
store the number 555-1212 under the index number 1 on the keypad:
The maximum number of digits that can be stored for any
phone number is 16 in PULSE or TONE mode. The maximum number of
digits for mixed (TONE and PULSE in combination) dialing is 15. If you are
using a switchboard system to access an outside line (such as needing to
press an 8 or 9 before dialing the number), press the RE/PA button to store
a PAUSE.
Press the TALK button.
Press the MEM button.
Press the index number for the number you have stored. The stored
number will be dialed automatically.
IMPORTANT:
Recalling Stored Numbers from Memory
Preparing for Use
Receiving Calls with the HANDSET on the BASE UNIT
Receiving Calls with the HANDSET off the BASE UNIT
Placing Calls
Redial Feature
1.
2.
1.
2.
3.
1.
2.
3.
NOTE: The BASE UNIT has no ringer and does not ring when receiving an
Incoming call.
1.
2.
3.
4.
1.
2.
3.
4.
Storing Numbers
1.
2.
3.
4.
5.
6.
7.
1.
2.
3.
EXAMPLE: To recall number 555-1212 stored under button 1 on the keypad:
- Press the TALK button.
- Press the MEM button.
- Press the button.
1 - Press the MEM button. 4 - Press 1 on the keypad.
2 - Dial 555 - 1212.
3 - Press the MEM button again.
Basic Operation
Basic Operation
89
5 - You have stored 555 - 1212 under
button 1 on the keypad.
A total of 10 telephone numbers can be programmed in memory