User's Manual

1.
2.
3.
4.
5.
6.
A.
B.
C.
T/P
TEL
-
+
POWER SOURCE 9VDC 200mA
USE ONLY WITH CLASS 2USE ONLY WITH CLASS 2
S/N.: C0000001
S/N.: C0000001S/N.: C0000001
LONG TELEPHONE
LINE CORD
TELEPHONE LINE
CONNECTION JACK
MOUNTING BRACKET
IN DESK MOUNT
POSITION
SHORT TELEPHONE
LINE CORD
WALL PLATE
WALL PLATE
TELEPHONE LINE
CONNECTION JACK
BASE UNIT
MOUNTING
BRACKET
IN WALL
MOUNT
POSITION
Belt Clip Mounting
TO REMOVE
TO INSTALL
BASE UNIT
120V WALL OUTLET
BASE UNIT
ANTENNA
BASE UNIT
TONE/PULSE
SELECT SWITCH
AC ADAPTOR
POWER-IN
SOURCE
TELEPHONE LINE
CONNECTION JACK
TELEPHONE
JACK
TELEPHONE LINE
CORD
Installation
Installation
67
Insert the small plug on the end of the AC ADAPTOR into the POWER-IN
CONNECTION JACK on the back of the BASE UNIT.
Plug the AC ADAPTOR into a 120VAC wall outlet.
Insert one plug of the TELEPHONE LINE CORD into the house TELEPHONE
JACK and the other plug into the TELEPHONE LINE CONNECTION JACK on
the back of the BASE UNIT. (If you have an older 4-prong TELEPHONE JACK,
you will need an RJ-11C TELEPHONE JACK ADAPTOR. This adaptor is
available at the same place you purchased your telephone.)
We recommend not placing this unit next to appliances. Doing so may cause
interference.
TONE/PULSE Select Switch:
If your home is equipped with a tone dialing system, set the TONE/PULSE
select switch to the TONE position.
If you have a rotary dialing system, set the TONE/PULSE select switch to
the PULSE position.
If you are unsure which system you have, set the TONE/PULSE select
switch to the TONE position. Press the TALK button on the HANDSET to
get a dial tone, and press any button on the keypad except the zero. If the
dial tone continues, you do not have tone dialing service. Press the TALK
button on the HANDSET to hang up. Ser the TONE/PULSE select switch
to the PULSE mode and try again.
Press the TALK button to confirm that you have a dial tone. If you do not get
a dial tone, review steps 1 through 5. If you still do not have a dial tone, refer
to the Problem Solving section on page 12.
Before initial use, charge the HANDSET for 12 hours.
You are now ready to use your new Cordless Telephone.
Desk Mounting
Wall Mounting
WALL PLATE
STUD