Installation Instructions
Table Of Contents
- (Ver.1.0)
- 1. Summary3
- 3. Major function
- 6. Attentions 10
- 10. FCC Caution11
- 1. Summary
- 2. Electrical characteristics and parameters
- 3. Major function
- 3.1 Radar operating range
- 3.2 Sleep detection function
- a. Detection distance: 2.5m (detection distance be
- antenna surface) The
- b. Sleep quality assessment function: awake / ligh
- c. Sleep time recording function: the data output
- duration of sleep quality
- d. In bed function: in / off bed
- 3.2.1 Respiratory detection function
- a. Detection distance: 0.4m≤x≤2.5m (detection dist
- b. precision:≥90%
- 3.2.2 Heart detection function
- a. Distance measurement: 0.4m≤x≤2.5m (detection di
- b. precision:≥95%
- 3.2.3 Existence of detection
- a. Detection distance: 2.5m (detection distance be
- b. precision:≥90%
- 3.2.4 Move detection
- a. Movement trigger
- 4. Radar operation and installation method
- 5. Typical application mode
- 6. Attentions
- 7. Disclaimer
- 8. Copyright description
- 9.Contact information
- 10.FCC Caution:
JR_G6T_AOP_PUB
Tel:0755-86567969 Mail: jhxk@xkgtech.com Address:912 5A Building,ECO-
Technology Park,Yehai street,Nanshan district,Shenzhen city,Guandong province,China
10.6 Antennas
This radio transmitter FCC ID: 2A784JRG6TAOPPUB has been
approved by Federal Communications Commission to operate with the
antenna types listed below, with the maximum permissible gain
indicated. Antenna types not included in this list that have a gain
greater than the maximum gain indicated for any type listed are
strictly prohibited for use with this device.
10.7 Label and compliance information
The final end product must be labeled in a visible area with
the following" Contains FCC ID: 2A784JRG6TAOPPUB”2.9 Information
on test modes and additional testing requirements
Host manufacturer is strongly recommended to confirm compliance
with FCC requirements for the transmitter when the module is
installed in the host.
10.8 Additional testing, Part 15 Subpart B disclaimer
Host manufacturer is responsible for compliance of the host
system with module installed with all other applicable requirements
for the system such as Part 15 B
Antenna Type
Frequency Range (MHz)
Impedance
(Ω)
Maximum antenna
gain(dBi)
Microstrip Patch
60-64GHz
50
5.0