User's Manual

Synchronization of the Collar Receiver to the Remote Transmitter.
• Electrodes: Contact points cover the electrodes, and through them electronic pulse
stimulation is delivered.
• Charging Port: Charges the battery of the Collar Receiver when connected to a power
source.
• Indicating Light: Flashes green when any of the stimulations are pressed. Will blink red if
the battery power is low to indicate the Collar Receiver needs recharging.
Operating Guide
Step 1 - Prepare the Remote Transmitter and Receiver Collar:
Charge the Remote Transmitter and Receiver Collar
1. Uncover the Charging Port by lifting the rubber cover.
2. Insert the charging connector into the Charging Port.
3. Plug the charger into a standard wall outlet.
4. A solid red light will appear on the Indicator Light, indicating charging is occurring.
5. Once charging is complete, the solid red light will turn to a solid green light.
6. Remove the charging connector, and replace the rubber cover to protect the Charging
Port.
Note: Before first use, charge the Remote Transmitter and Receiver Collar until completion.
Powering on and off the Remote Transmitter
Press the ON/OFF button on the transmitter to power the unit on or off. When the transmitter is
powered on, the indicating light will flash green.
Powering on and off the Collar Receiver
Press the ON/OFF button on the receiver to power the unit on or off. When the receiver is
powered on, the indicating light will flash green.
Step 2 – Pairing Collar Receiver to Transmitter
Note: Transmitter and receiver are pre-paired when leaving our manufacturing facility. In case
the pairing is not established or you would like to repair the units, please follow the instructions
below:
1. Power on the Collar Receiver by pressing the ON/OFF button on the Collar Receiver.
2. Press and hold the ON/OFF button for about 3 seconds until a beep sounds, and the
indicating light will begin flash quickly.
3. Press any button on the transmitter once the Collar Receiver beeps. When the Remote
Transmitter and Collar Receiver are paired successfully the indicating will stop flashing
quickly.