Setup Instructions

Troubl
eshooting
Sym
ptom
Poss
ible Problem
Sol
ution
Cannot power on
Check Speak
er Dock whether
power on or not, check whether
adaptor is firmly mount to Speaker
Dock's connector.
Power on Speaker Dock, pull and insert the
adaptor to Speaker Dock’s connector again.
No sound
Speak
er Dock input source not
switch to IPOD channel.
Speaker Dock input source select to IPOD
channel.
Cannot automatic
connection
A
dapter auto connect timeout and
enters standby mode.
Press remote controller “PAIR” key , wait
and it will reconnect in few seconds; Also,
use remote controller “Power on/off” key to
power off and power on it again can force it
reconnect.
Cannot discover
adapter
Adapter not enter pairing mode
Press remote controller “PAIR” key, then the
Red LED and Blue LED flashing alternately,
indicate it entered pairing mode.
Remote controller
no function
Batt
ery (CR2025) exhausted,
remote distance or angle out of
range
R
eplace a new battery (CR2025);
Use the remote controller within an effective
distance (about 6 meters).
Stora
ge & Maintenance
■ Please store the wireless adapter in a cool and dry place. The working temperature is -10～45°C
( 14～113°F).
■ Adapter is not waterproof, please don't put the adapter into water,
■ please use soft cloth to wipe clean.
■ Do not use any sharp objects in connect with adapters.
■ Do not use in extremely high or low temperature or humid environment
Note： Design and specifications are subject to change without notice.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause undesired operation.