Setup Instructions

Pairing Method
■ When first time use the adapter it automatically enter pairing mode when power
on(Red LED and bule LED flashing alternately).If it doesn't enter pairing mode,
please press “PAIR” key on remote controller to make the adapter enter pairing
mode.
■ Open the BT setting on your cellphone or the devices with BT function, then search
the BT devices and choose pairing name “C30”,Enter “0000” pin code if needed.
■ The Blue LED flash slowly when it is paired successfully.
Note：
1. When the distance between the adapter and the BT devices is far than 10 meters (33
feet), the adapter may disconnect from the devices. After that, once the they are in
the range of 10 meters (33 feet), they will automatically reconnect. But if the
adapter disconnects from the device over 3 minutes it may enter timeout mode and
cannot automatically reconnect, this time need to press “PAIR” key on remote
controller to reconnect or reconnect it at cellphone BT setting menu.
2. If the adapter has paired, you can force the adapter “Enter pairing mode” again
which another cellphone can find the adapter and connect it.
Connect Two Devices
■ Follow the pairing method, pair the first cellphone and then “Enter pairing mode”
again to pairing the second cellphone.
■ Enter the cellphone setting interface of the first cellphone, and connect the device
C30 again.
LED Indicator
■ Red LED always on: Power off
■ Red LED and Blue LED flashing alternately: pairing mode
■ Blue LED flashing slowly: connected/playing music
■ Red LED short light once: Remote controller’s command received indicator.
Specification
■ BT effective range：10 meters (33 feet)
■ Remote controller effective range：6 meters (20 feet)
■ Remote controller battery：CR2025