User's Manual

IFW01 Wireless Charger With Night Light

It can be compatible with all mobile phones

comply with QI standard. Also support fast

wireless charging-charging power at 5W,7.5W,10W.

Its design is creative,simple and modern.And it can

be used in these places,such as family,bedroom,

oﬃce,hotel etc.

1.Touch Swith

2.Support Fast Wireless Charging

3.Night Light In Dark

Night Light Mode

1.Please use proper phone adaptor comply with

QC protocol to charge this device(Check the

picture as below)

2.Indicator lights will ﬂash between blue and

white light, then white light is always on, which

means it is used properly.

3.Charge your mobile phones in the power sensor

area, when white light turns into blue light, then

mobile phones receive the power charging signal,

which means its power charging function is

working good. After fully charged, the light will be

white.

A.First touch, brightness is 100%

B.Second touch, brightness is 50%

C.Third touch, brightness is 10%

D.Fourth touch,it will be turned oﬀ

4.Night light mode: touch to turn on the light.

1pc 100cm USB Cable

1pc User Manual

1pc Package Box

1.Please keep it far away from water or other liquid

2.Please turn it oﬀ if you want to clean it up

3.Working temperature should be -20~45℃

Input Voltage: DC 5V 2.1A 9V 2A

Power: 5W/7.5W/10W/15W

Power Conversion Eﬃciency: 75%

Charging Port: Type-C

Thanks for choosing this phone wireless charger. In order to use it in a safe and

convenient way, please read the manual carefully to ensure your better using experience.

PAGE 1
IFW01 Wireless Charger With Night Light 4.Night light mode: touch to turn on the light. Its design is creative,simple and modern.And it can be used in these places,such as family,bedroom, oﬃce,hotel etc. It can be compatible with all mobile phones comply with QI standard. Also support fast wireless charging-charging power at 5W,7.5W,10W. 1.Touch Swith 2.Support Fast Wireless Charging 3.Night Light In Dark 1.
PAGE 2
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.