Quick Start Guide

FCC WARNING:
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following
measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and
receiver.
-Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV
technician for help.
* RF warning for Portable device:
The device has been evaluated to meet general RF
exposure requirement. The device can be used in
portable exposure condition without restriction.
This device complies with part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference,
and (2) this device must accept any interference
received, including interference that may cause
undesired operation.
Quick start guide
1.Scan QR Code to download app.
3.Install the earpick firmly on the otoscope
tip when you need to pick your ear (If you
purchased one with a base, please open
the base and select the appropriate ear
spoon)
6.The inside of the ear can be observed in
real time by the App.And the transparent
earpick won’t block your view.
7.Screen lock is designed to avoid
misoperation of children.
4.Connect product WiFi:weiview-xxx.
5.Return to the App then click “start” to
inspect ear.
2.Remove the lid and the otoscope will be
power on automatically.
8.Low battery alert.
When the battery is low, the red light
flashes,please charge in time
Product size
Product parameters
Product name: Wireless Smart Otoscope
Product Model: T1 T2
Image transfer rate: 25fps
Image transmitter: CMOS
Operating ambient temperature: -10~50°C
Battery type: Lithium battery
Battery life: approx 1 hour
Charging time: 1 hour
Input current: DC 5V 300ma
Probe diameter: 3.9mm
Optimnm focal length: 1.0-1.5cm
Gravity sensor: 3 Axis Gyro
Fault analysis and troubleshooting
Notes
1. Please observe the surroundings before use , and don't use the
product while running to avoid impact.
2. Before use , be sure to install a protective pear-picking rod and fasten
the head of the ear-picking rod to protect your ears.
3. This product is not suitable for children under 6 years old.
4. It is prohibited for children to use this product alone to avoid careless
harm.
5. Please store the product in the normal temperature and avoid direct
sunlight to avoid product damage.
6. The APP can not compatible with Samsung S7.
7. When cleaning the lens , please wipe carefully with the professional
alcohol cotton swab provided
8. In order to ensure the best use experience, please keep the child in a
seated position and operate the product horizontally when picking the
ear for the child .
9. FCC statement: This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
1)This device may not cause harmful interface;
2)This device must accept any interference received, including
interference that may cause undesired operation.
10. ROHS compliance: This product is in compliance with Directive
2011/65/EU of the European Parliament and of the Council of 8 June
2011 on the restriction of the use of certain hazardous substances in
electrical and electronic equipment.
Faults Solution
No response on startup.
Try the correct boot method a few more
time.
Please charge with a matching charging
cable for 1hour,
Camera doesn't light.
Shutdown and restart the otoscope.
App crashing.
Uninstall the existing APP and rescan
the QR code for installation.
Power indicator light
flashes.
There is not enough electricity.please use
the the matching charging cable for charging,
and the charging time is 1 hour.
The product failed to
properly display real-time
images after successfully
connecting to APP.
Disconnect the phone from the otoscope
WiFi, restart the otoscope, and
reconnect the WiFi.
The WiFi connection is
unstable and sometimes
disconnected in seconds.
Restart the otoscope and reconnect the
App
If the above operation fails to solve the problem, please contact
customer service, we will further provide you with a practical solution,
Wireless
smart otoscope
Professional Otoscope
Otoscope General Manual
Otoscope power-on prompt light is
green
(T1)
128mm
15 mm
(T2)
130.35 mm
15mm