User's Manual Part 1

2. Installing memory

Please install the memory in accordance with the following procedures:

· Remove the white buckle at the two ends of the interface slot for the memory;

· Align the golden finger of the memory to the groove of the interface slot and

pay attention the concave hole of golden finger should be aligned to the

convex point of the slot.

· Finally, insert the memory into the interface slot gently. If no error occurs at

the moment, insert the card forward in the slot till the white buckle is

automatically engaged in the concave hole at the two sides of the memory.

Note

In order to avoid damages to the motherboard or the components, the user must

make sure the power supply to the computer is turned off before the memory or

other component is installed or removed. As the groove is set at the golden finger

of the DDR DIMM, the memory can only be inserted into the slot with one direction.

During installation, the user only needs to align the golden finger and the

dual-channel groove of the interface slot and insert it gently. To avoid damage,

never apply excessive force in that process.

3. Install expansion slot card

3.1 Install graphic card

This motherboard provides one interface slot for PCIE 16x AGP. When you

install the PCIE graphic card, you should note that groove of the golden finger

must be exactly engaged into the interface slot. In that process, it is preferable

that you are in grounded state, and you should carefully take out the graphic

card from the anti-static bag. Then align the graphic card to the PCIE slot and

insert it. After that, tighten the screw on the metal baffle.

switch out the white buckle on

both ends of the DIMM

Bracket Screw

Graphic card

Motherboard