User's Manual


In the frame of home interface, it will show the last measurement as picture
App 09. You can
check the measurements with detail by clicking the History button as picture
App 10 and app 11 .
e)Checking the measurement
2 ) Operate on the device
a) Press the START/STOP button. The pump begins to inflate the cuff. In the
display, the increasing cuff pressure is continually displayed.
b) After automatically reaching an individual pressure, the pump stops and
the pressure slowly falls. The cuff pressure is displayed during the
measurement.
c) When the device has detected your pulse, the heart symbol in the display
begins to blink.
d) When the measurement has been concluded, the measured systolic and
diastolic blood pressure values, as well as the pulse will be displayed.
e) The appearance of this symbol signifies that an irregular heartbeat was
detected.This indicator is only a caution. It is important that you be relaxed,
remain still and do not talk during measurements.
f) The measurement results are displayed until you switch the device off. If no
button is pressed for 60 seconds, the device switches off automatically.
g) Cuff self-checking symbol ( )
The cuff correct symbol( ) will be displayed if the cuff position is correct,
otherwise the wrong symbol( ) will be displayed. Please check again the
cuff if the wrong symbol( ) is displayed.
h) Movement error symbol ( )
The Movement Error Symbol ( ) is displayed if you move your body during
the measurement. Please remove the cuff, and wait 2-3 minutes. Reapply the
cuff and take another measurement.
Patient Position:
1) Comfortably seated
2) Legs uncrossed
3) Feet flat on the floor
4) Back and arm supported
5) Middle of the CUFF at the level of the right atrium of the heart
NOTE:
App09 App10 App11