User's Manual

300M Wireless AP

clients. The device's SSID won't be changed.

1. SSID: You can configure the uplinked AP's SSID name here.

2. Security Mode: You can configure the uplinked AP's security mode here.

3. MAC Address: You can configure the uplinked AP's MAC address here.

4. Uplink AP Channel: You can configure the uplink AP's channel here.

5. Enable Scan: Scans wireless signals nearby.

4 LAN Setup

Here you can configure the LAN IP address and subnet mask.

1. MAC Address: Displays the LAN’s MAC address.

2. Address Mode: Two modes are available: Static IP and Dynamic IP.

3. IP address: Displays the device’s LAN IP address. When the address mode is Static IP, you can change it

as you need. The default is 192.168.0.254.

4. Subnet Mask: Displays the device’s LAN subnet mask. The default is 255.255.255.0.

5. Gateway: Displays the device’s gateway.

6. Device Name: Displays the device name.

Note

If you change this IP address, you must use the new one to re-log on to this web utility.

5 Wireless

5.1 Basic

This section describes how to configure the available wireless settings.