User's Manual

300M Wireless AP
14
3.2 WDS Mode
In this mode, this device can provide access to at most 4 APs.
1. SSID: Displays the device’s SSID. The default is this device's primary SSID. Once WDS is enabled, the
primary SSID will be modified to the first remote AP's SSID.
2. Security Mode: You can configure primary SSID's security mode and it should be kept the same as that of
the remote AP.
3. MAC Address: You can enter the remote MAC address manually or open scan to add it automatically.
4. Uplink AP Channel: When WDS is enabled, please keep all APs on the same channel.
5. Enable Scan: Scans wireless signals nearby.
Note
1. In WDS mode, the two APs should support WDS and you should keep their SSIDs, channels, security
modes and keys the same. As for IP address, they should not be the same but on the same network segment;
2. Once the security mode has been changed, please reboot the device.
3.3 AP Client Mode
In this mode, this device negotiates with the uplinked AP successfully and also provides access to lower