User's Manual

23
Application Scenario:
There’s already an AP (Hereinafter referred as the remote AP) installed on the second floor of a hotel. Due to
limited WiFi coverage or other objects’ intereference, some rooms of the hotel on the second floor may be
unable to enjoy WiFi smoothly. Then you can install one more AP in the room where WiFi signal is not strong
enough for WiFi extension. In this mode, you have no need to configure any WDS settings on the remote AP.
Before configuring AP Client settings, verify the following information of the remote SSID: SSID (WiFi name),
channel and encryption information.
Assuming information of the remote device is as below:
SSID: IP-COM_130518
Channel: 6
Security Mode: Mixed WPA/WPA2-PSK
Cipher Type: AES
Security Key: 12345678
Configuration Steps:
❶ Select APClient Mode and click Enable Scan.