User's Manual

84
Configuration Procedure
1. Configure the AP.
By default, the deployment mode of the AP is Local. Use the default configuration.
2. Configuring the AP controller.
By default, AC2000 works in Sub AC mode. Use the default configuration of the AP controller.
---End
Verification
Log in to the web UI of AC2000 and access the Manage AP page to verify that all APs are online.
You can use AC2000 to manage the APs in a centralized manner.
4UZK
After the AP controller takes control over the APs, it changes the IP addresses of the APs. To log in to the web UI of an
AP, log in to the web UI of the AP controller and click the IP address of the AP.