User's Manual

80
 Configuration Procedure
1. Configure the AP.
Assume that the read community is Tom and read/write community is Tom123.
(1) Log in to the web UI of the AP and choose SNMP.
(2) Set SNMP to Enable.
(3) Set the SNMP parameters.
(4) Click Save.
2. Configure the NMS.
On an NMS that uses SNMP V1 or SNMP V2C, set the read community to Tom and read/write
community to Tom123. For details about how to configure the NMS, refer to the configuration guide
for the NMS.
---End
 Verification
After the configuration, the NMS can connect to the SNMP agent of the AP and can query and set
some parameters on the SNMP agent through the MIB.