User's Manual

79
---End
Parameter description
Parameter
Description
SNMP
It specifies whether to enable the SNMP agent function of the
default, it is disabled.
The SNMP manager and SNMP agent can communicate with each other only if their SNMP
versions are the
same. Currently
, the SNMP agent function of the AP supports SNMP V1
and SNMP V2C.
Administrator Name
It specifies the name of the administrator of the AP. The default name is Administrator.
Device Name
It
specifies the device name of the AP. The default device name is the model of the AP.
For
example, the device name of AP375 is AP375.
4UZK
It is recommended that you change the AP name so that you can easily identify the AP
when managing the AP using SNMP.
Lo
cation
It specifies the location where the AP is used.
Read Community
It specifies the read password shared between SNMP managers and this SNMP agent.
The default password is
public.
The SNMP agent function of the AP allows an SNMP manager to use the password to read
variables in the MIB of the AP.
Read/Write
Community
It specifies the read/write password shared between SNMP managers and this SNMP
agent. The default password is
private.
The SNMP agent function of the AP allows an SNMP manager to use the p
assword to
read/write variables in the MIB of the AP.
 Example of Configuring the SNMP
Function
 Networking Requirement

The AP connects to an NMS over an LAN. This IP address of the AP is 192.168.0.254/24 and
the IP address of the NMS is 192.168.0.212/24.

The NMS use SNMP V1 or SNMP V2C to monitor and manage the AP.