User's Manual

62
Parameter
Description
SSID
It specifies the SSID that re
quires wireless client access control.
MAC Filter Mode
It specifies the mode for filtering MAC addresses.
−
Disable: It indicates that access control is disabled.
−
Allow
: It indicates that only the wireless clients on the access control list can connect
to the AP with the selected SSID.
−
Deny: It indicates that only the wireless clients on the access control list cannot
connect to the AP with the selected SSID.
 Example of Configuring Access Control

Networking requirement
A hotel has set up wireless networks and designated the SSID Ordering corresponding to RF band
2 for placing orders. The AP must be configured to allow only ordering devices to connect to the
wireless network corresponding to the SSID.
You can use the access control function of the AP to address this requirement. Assume that there
are three ordering devices whose MAC addresses are C8:3A:35:00:00:01, C8:3A:35:00:00:02, and
C8:3A:35:00:00:03.

Configuration procedure
1. Choose Wireless > Access Control and click the Radio 2 tab.
2. Select Ordering from the SSID drop-down list box.
3. Select Allow from the MAC Filter Mode drop-down list box.
4. Enter C8:3A:35:00:00:01 in the
MAC Address text box and click Add. Repeat this step to add
C8:3A:35:00:00:02 and C8:3A:35:00:00:03 as well.
5. Click Save.
---End
The following figure shows the configuration.

Verification