User's Manual
61
Access Control
Overview
It specifies, based on MAC address filter rules, the wireless devices that can or cannot access the
wireless networks of the AP. Devices that have been controlled cannot connect to the corresponding
wireless network.
The AP supports the following MAC address filter rules:
Disable: It indicates that access control is disabled. In this case, all wireless devices can access
the wireless networks of the AP.
Allow: It indicates that only the wireless devices with the specified MAC addresses can access
the wireless networks of the AP.
Deny: It indicates that only the wireless devices with the specified MAC addresses cannot
access the wireless networks of the AP.
Configuring Access Control
1. Choose Wireless > Access Control.
2. Click the tab of the RF band on which access control must be implemented.
3. From the SSID drop-down list box, select the SSID of the RF band on which access control must
be implemented.
4. Select an access control mode from the MAC Filter Mode drop-down list box.
5. If you select Allow or Deny, enter the MAC addresses to control in the control list and click Add.
6. If a wireless device to be controlled has been connected to the AP, you can click Add
corresponding to the device in the wireless client list to directly add it to the control list.
7. Click Save.
---End
Parameter description
=OXKRKYYIROKTZROYZ
=OXKRKYYGIIKYYIUTZXURROYZ