User's Manual

21
 DHCP Server
 Overview
The AP provides a DHCP server function to assign IP addresses to clients on the LAN. By default,
the DHCP server function is disabled.
4UZK
If the new and original IP addresses of the LAN port belong to different network segment, the system changes the IP
address pool of the DHCP server function of the AP so that the IP address pool and the new IP address of the LAN
port belong to the same network segment.
 Configuring the DHCP Server
1. Choose Network > DHCP Server.
2. Set the parameters.
3. Click Save.
---End
Parameter description
Parameter
Description
DHCP Server
It sp
ecifies whether to enable the DHCP server function of the default, it is disabled.
Start IP
It specifies the start IP address of the IP address pool of the DHCP server. The default value
is
192.168.0.100.
End IP
It specifies the end IP address of the IP address pool of the DHCP server. The default value is
192.168.0.200
.
4UZK
The start and end IP addresses must belong to the same network segment as the IP address
of the LAN port of the AP.