User's Manual

---End

If you change the IP address of the LAN port, change the IP address of your management computer

as well so that the two IP addresses belong to the same network segment. Then, you can use the

new IP address of the LAN port to log in to the web UI of the AP.

Automatically Obtaining an IP Address

This mode enables the AP to automatically obtain an IP address, subnet mask, gateway IP address,

primary DNS server IP address, and secondary DNS server IP address from a DHCP server in the

network. If a large number of APs are deployed, you can adopt this mode to prevent IP address

conflicts and effectively reduce your workload.

Procedure:

1. Choose Network > LAN Setup.

2. Set Address Mode to Dynamic IP.

3. Click Save.

---End

After the configuration takes effect, you can log in to the web UI of the AP only with the IP address

assigned to the AP by the DHCP server. The IP address is specified on the client list of the DHCP

server.