User's Manual

104
A4. After the AP is powered on, use a pin to hold down the RST button for 8 seconds and then wait about
1 second. After the factory settings are restored, configure the AP again.
Q5. What should I do if a computer connected to the AP displays an IP address conflict
message?
A5. Check the following items:

Verify that the IP address of the computer is not used by another device on your LAN. The
default IP address of the AP is 192.168.0.254.

Verify that the static IP addresses assigned to computers on your LAN are not used by other
devices.
For more technical assistance, visit our website at http://www.ip-com.com.cn or send your question to
[e-mail], or call [phone]. We will help you resolve your problem as soon as
possible.