User's Manual

8
Operating instructions
Powering / charging devices with T-1000
T-1000 accessory list
MC4-7909
connector cable
12V Car Charger
cable
User Manual
Recommend to use 150W/200W Solar panel (not included).
AC 100-240V wall plug
power adapter
CHARGING T-1000
Connect the provided AC wall power adapter to DC port, and charge it to full approx. 7-8 hours.
When it is charging, the LCD Screen will be illuminated, and the LCD display will provide Battery
level Indicator, T-1000 is charged when the level is 100% and the current will get smaller and
smaller until it is stop charging.
The output port will not work until the appropriate button is pressed to activate the output ON/OFF
button C/D/E. When it was activated, the LCD display will turn on and it will display the details of
the power of input or output. The LCD Screen will automatically shut down when no outputs are
activated.
Pass-through charging
The advanced battery management system of the T-1000 allows it to charge a connected device
via DC/AC output & USB output while charge the T-1000.
OVERLOAD
If an overload occurs on the output, T-1000 will:
Automatically turn off AC Output power.
The indicator light of LCD Screen still illuminated.
DC output status still the same status as usual.
Do as following:
Check the output power of the load, unplug it.