User's Manual

OPERATING INSTRUCTIONS
CHARGING G300
Connect the provided AC Wall power adapter to Input, and allow G300 to fully
charge prior to use, approx. 6-7 hours.
When charging, the LCD Screen will be illuminated, and the LCD display will
provide Battery level Indicator, G300 is fully charged when the level is 100%.
It is recommended to fully charge G300 every 3 months to maintain the health of
the battery pack.
POWERING / CHARGING DEVICES WITH G300
Select the type of outlet required by pressing the Output ON/OFF Button C/D/E.
The output port will NOT function until the appropriate button is pressed to
activate the port. When activated, the indicator on the button will illuminate
green, indicating that the output(s) are active, and the LCD display will turn on
and provide details on the charging output. The LCD Screen will automatically
shut down when no outputs are activated.
The advanced battery management system of the G300 allows
it to charge a connected device via DC output & USB output while charge the
G300.
DO NOT CONNECTED DEVICE VIA AC OUTPUT WHILE CHARGE THE
G300.
OVERLOAD CONDITION
If an overload condition occurs on the OUTPUT port,G300 will:
Automatically turn off AC Output(6)power.
The blue indicator light of LCD Screen(1)still illuminated.
DC OUTPUT Status J still the same status as usual.
Do following:
Check the input charge cable. The port will be efficient when the input charge
cable meets the specification outlined in the GENERAL SPECIFICATIONS section.
Only charge G300 with provided AC wall power adapter.
PASS-THROUGH CHARGING
8
G300 ACCESSORY LIST
MC4-7909
connector cable
12V Car Charger
cable
User Manual
Recommend to use 100-120W Solar panel (not included).
AC 100-240V wall plug
power adapter