Instructions for Use Wireless Charger
EN | 2 Wireless Charger Instructions for Use Content 1. General 4 2. Intended Use 4 3. Delivery Scope 4 4. Important Safety Instructions 4 5. Start-up 6 6. Technical Data 8 7. Exclusion of Liability 9 8. Warranty 9 9. Declaration of Conformity 9 10.
EN | 3 Wireless Charger Instructions for Use 1. General The Wireless Charger is an inductive charging station. Please read the instructions carefully before use. 2. Intended Use This product is intended for wireless charging. 3. Delivery Scope • Wireless Charger • USB cable • Instructions for Use (digital) 4. Important Safety Instructions 1. Do not use the wireless charger for anything other than its intended use. 2.
EN | 4 Wireless Charger Instructions for Use charger to avoid possible interference with the medical device. Consult a physician before using the wireless charger. 7. Keep the wireless charger out of the reach of children. 8. The wireless charger is designed for indoor use only. 9. To protect the wireless charger against contamination and damage keep it closed and away from children, dust, sunlight, moisture, pets and vermin. 10.
EN | 5 Wireless Charger Instructions for Use 5. Start-up Output: 5V, 2A 1 2 US BT yp e-C 1. Connect the power adapter to a power socket. The green indicator on the side of the wireless charger will glow solid green to indicate that a power connection is established. 2. Connect USB-A end of the supplied cable to a power adapter with at least 2 A output.
EN | 6 Wireless Charger Instructions for Use 3. Connect USB-C end of the cable to the wireless charger. 4. When power is supplied to the wireless charger, the LED will turn on. Note: Please make sure that you use a power adapter with an output of 9V DC @ 1.8A or 5V DC @ 2A. The power adapter is not part of the scope of delivery.
EN | 7 Wireless Charger Instructions for Use 1. Place the device centered on top of the wireless charger 2. When the LED of the wireless charger turns off, charging is in progress. Note: If the LED of the wireless charger flashes, an error has occurred. In this case, please remove all objects from the wireless charger and place the device on the wireless charger again. Attention • Make sure that the wireless charger is connected to a working power socket.
EN | 8 Wireless Charger Instructions for Use Status display LED Temperature range 0°C to 35°C / 32°F to 95°F Relative humidity 15 % to 85 % IP classification 42 7. Exclusion of Liability The firmware and/or hardware may be changed at any time without prior notice. For this reason, it is possible that parts of these instructions, technical data and images in this documentation differ slightly from the product in your possession.
EN | 9 Wireless Charger Instructions for Use 9. Declaration of Conformity www.healyworld.net/doc/declaration/hw01 10. Used Symbols and Icons In conformity with European legislation Electronic waste – do not dispose. Recycle acc. to local regulations or contact your authorized dealer or the manufacturer.
EN | 10 Wireless Charger Instructions for Use The Eurasian Conformity mark (Armenia, Belarus, Kazakhstan, Kyrgyzstan, Russia) Ukrainian conformity mark Malaysian Communications and Multimedia Commission Type approval for fixed line and wireless telecommunications products Use only inside © 2022 Shenzehn Input Technology Co. Ltd. All rights reserved. Shenzehn Input Technology Co. Ltd.
FCC Warning Statement: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
