PREFACE Thank you for your purchase of the HYT Patrol Recorder (referred to as “Patrol Point” below). We believe this easy-to-use Patrol Point will provide you with reliable, convenient, and efficient patrol management service. To enable you to fully understand the performance, usage and maintenance of this device, please read this manual carefully before use.
IMPORTANT REGULATORY INFORMATION This device complies with Part 15 of the FCC Rules: Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference that is received, including any interference that may cause undesired operation. WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
IMPORTANT: The END-USER of this device shall be responsible for submitting updated information in the event the operating location or other information changes after the initial registration. The grantee shall notify the user of this requirement.
Contents Precautions and System Maintenance Product Inspection System Composition Patrol Point (Transmitter) Patrol Radio (Receiver) Patrol Management Software Applied Solution Installation
Precautions and System Maintenance ¾ ¾ ¾ ¾ There are two types of Patrol Points: Patrol Point with Adapter Jack and Patrol Point without Adapter Jack. The former one is used indoors and adopts the power supply with adapter or battery. The latter one is used indoors and outdoors, and can be powered by battery only. When used indoors, it is suggested to adopt the Patrol Point with Adapter Jack, to use the power supply with adapter and ensure long-time reliable operation.
System Composition The patrol management system is made up of the following parts: ◆ Patrol Point (transmitter) 1) It is to encode such information as the current Patrol Point ID, time and battery status and then transmit it in the form of radio signals. Precise clock chip is installed in the Patrol Point and supplied with a dedicated battery. The clock can be calibrated via PC programming. 2) Operating Mode: The Patrol Point can operate in the following modes: 2.
battery capacity and lasts longer if with longer transmit interval, lower transmit power and higher battery capacity. It is suggested to use high capacity alkaline battery or rechargable battery. 3.4 Operating Temperature: -40℃/+70℃ ◆ Patrol Radio (receiver) TK SK1 SK2 Besides the available functions and features of conventional radio, the Patrol Radio used in the patrol management system is also capable of receiving information transmitted from Patrol Point.
◆Applied Solution: a. At each place where the patrol person is required to patrol install a Patrol Point, which transmits patrol information regularly. b. When the patrol person with Patrol Radio passes by the Patrol Point, the Patrol Radio will receive and automatically record the patrol information, and also can send the patrol information to the patrol management softare. c.
and open the Patrol Point. 3. Drill four holes in proper places in the wall, the diameter of which should be consistent with that of the green rubber stopper. The place and size of the hole are shown as the following figure. Then lay the four green rubber stoppers, with the face parallel to the wall, shown as the following figure. 99.30 62.20 59.60 3. Fasten the four O-ring screws (PTS3.3X20) to fix the chassis onto the wall.
4. Place the front cover on the chassis. Lock the four screws in the indicated directions and then fasten one screw to fix the cover, shown as the following figure.
5. If the power of the Patrol Point is supplied through adapter, insert one end of the adapter into the transmitter, and the other into the AC socket, shown as the following figure.
HYT endeavors to achieve the accuracy and completeness of this manual, but no warranty of accuracy or reliability is given. All the above specifications and design are subject to change without notice due to continuous development. No part of this manual may be copied, reproduced, translated, stored in a retrieval system, distributed, or transmitted in any form or by any means, electronic or mechanical, for any purpose without the express written permission of HYT.
