User Manual

TR-800 Service Manual
-39-
Figure 5
Removing and Installing the Radio
1. Remove the screw (M4.0X6.0) that secure the ① thermistor sensor using a screwdriver, shown as
Figure 6.
2. Remove the eight screws (M3.0X6.0) that secure the bracket of radio using a screwdriver, shown ②
as Figure 6.
3. Remove the bracket ③ shown as Figure 6, and remove the 2 signal cables and 2 power cables of
both radios.
4. Remove the eight screws (M4.0X6.0) that secure both radios using a screwdriver, and then ④
remove both radios , shown as Figure 7.⑤
5. Install both radios as the reverse steps.
Figure 6 Figure 7
Removing and Installing Housing
1. Remove the six screws (M3.0X6.0) that secure the housing using a screwdriver, to remove the
housing ①, shown as Figure 8.
2. Install the housing as the reverse steps.
3
1
2
2
2
2
2
2
2
2
5
4
4
4
4
4
4
4
4