User Manual

Table Of Contents

TR-800 Service Manual

-37-

 Disassembly and Installation

Removing and Installing the Top Cover

1. using a screwdriver to Remove the seven screws (M3.0X6.0) that locking the top cover of ①

repeater, shown as Figure 1.

2. Remove the top cover , shown as Figure 1.②

3. Install the top cover as reverse steps.

Figure 1

Removing and Installing the Front Panel

1. Press the 6 latches that locking the front panel to the housing to separate and remove them from

the housing , s① hown as Figure 2.

2. Remove the front panel shown as Figure 2, and pull out the two ② set of jumper wires, two repeater

cables, accessory connector cable, and connecting cable of the DC power indication LED.

3. Install the front panel as reverse steps.

Figure 2