User's Manual

Code Squelch

The code squelch feature can be programmed by your

dealer.

If this feature is activated, squelch turns on only when the

received DTMF/2-Tone/5-Tone code matches the radio ID

code (set by your dealer). Otherwise, your radio will not

respond to the calls.

¡ö¡ö

¡ö

Receive

1. When the received DTMF/2-Tone/5-Tone code matches

the radio ID code (set by your dealer), squelch turns on

and you will hear the call without any further action

after an alert tone/Transpond finishes.

2. “CALL” icon appears on the LCD and radio LED flashes

orange.

3. Signalling squelch will turn back ON when you press

the key programmed as [MONI] or when no signal is

received for the preset time period.

4. The radio can be programmed to sound an alert tone

when receiving a matching code.

Basic Operations

If Transpond for Code Squelch function is enabled, the

radio will send a transpond signal (programmed by your

dealer) to the calling station when receiving the match-

ing code. The Transpond for Code Squelch function

can not be used in Group Call mode.

¡ö¡ö

¡ö Transmit

1. Hold down the [PTT] key.

2. Enter the preset DTMF code (ID code of the called radio

or group) through the keypad.

z If desired, you can use “store and send” or “speed

dial” function to transmit codes. Then operates the

mobile radio in the same way as a portable radio.

z During code transmission, “CALL” icon appears on

the LCD and radio LED glows red.

z Please refer to the [TTS], [FTS] key for 2-Tone/

5-Tone transmission.

3. Release the [PTT] key, signalling squelch will turn OFF

and LED flashes orange. Radio LED glows green when

a signal is received and flashes orange again when the

signal drops out.

ＴＭ８００．ｐ６５ 2005-6-29, 10:1623