User's Manual

Battery storage notice

1. Due to the self-discharge, the battery which will not be used for a long time should

be stored after full charge to avoid the damage to the battery because of

over-discharge.

2. Take out the battery stored for about 6 months to charge it, to avoid the influence of

electrolyte over-discharge on battery capacity.

3. Notice the ambient humidity and temperature for the battery storage. Please store it

in cool dry area with room temperature, to decrease self-discharge.

Battery charging

When radio LED flashes red and three Beeps sound every 30 seconds after the battery

is installed, that means battery power is low. Please charge the battery.

You are recommended to use HYT-approved, supplied charger; Charger LED will

indicate the charging status.

1. Plug the power cable into the adapter.

2. Plug the DC socket of adapter into the DC jack on the rear of the charger.

3. Insert the battery or the radio with battery into the charger cup.

4. Plug the AC socket of adapter into an AC outlet.

5. Make sure that the battery connectors are in contact with the charging terminals; the

charger LED glows red and charging begins.

6. The charger LED glows green when the battery is fully charged in about 3 hours,

please remove the battery or the radio with battery from the charger.

*Notes: Charger LED may flash red if you put the battery into the charger, which is a

normal pre-charge process for the charger to protect the battery when the battery power

is low. It will turn to normal charge status (glow red) after 30 seconds.

LED Indication

Flashing red Low battery voltage

Red Charging

Green Fully charged