User's Manual

 FCC Compliance

Part 15 Compliance

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there is

no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by

turning the equipment off and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

　 Reorient or relocate the receiving antenna.

　 Increase the separation between the equipment and receiver.

　 Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

　 Consult the dealer or an experienced radio/TV technician for help.

Modifications not authorized by the manufacturer may void users authority to operate this

device.

FCC Licensing Requirements

Your radio must be properly licensed Federal Communications Commission prior to use. Your

HYT Wireless dealer can assist you in meeting these requirements. Your dealer will program

each radio with your authorized frequencies, signaling codes, etc., and will be there to meet

your communications needs as your system expands.

 Precautions

• Only qualified technicians are allowed to maintain this product.

• Do not use the radio or charge a battery in explosive areas such as coal gas, dust, steam,

etc.

• Switch OFF the radio while refueling or parking at gas station.

• Do not modify or adjust this radio for any reason.

• Do not expose the radio to direct sunlight over a long time, nor place it close to heating