User's Manual

TC-700 Software Specification

3. Wireless Clone Mode

Select wireless clone from optional functions in programming software, turn the power on while

holding down PTT and SK1 key simultaneously for 2 seconds, then the source and target radios

enter wireless clone mode with orange LED flashing one time（After the source and target radios are

turned on and stay in the same channel, hold down PTT on the source radio to begin cloning）.

During cloning, the LED of the source radio glows red and that of the target radio glows green. The

target radio flashes green and two Beeps are heard in case of successful cloning, it flashes red in

case of cloning failure.

4. User Wired Clone Mode

Select Wired Clone from optional functions in programming software, turn the power on while

holding down PTT and SK2 key simultaneously for 2 seconds, then the source radio enters user

wired clone mode with orange LED flashing twice. Then directly turn the target radio on. Hold down

PTT on the source radio to begin cloning. During cloning, the LED of the source radio glows red and

that of the target radio glows green. The LED of the source radio goes out in case of successful

cloning, it flashes red in case of cloning failure.

5. Manual Adjust Mode

Manual adjustment is performed to adjust frequency deviation, power, sensitivity, squelch, etc.

Note: Prior to entry for mode startup, select Manual Adjust Mode from optional functions in

programming software.

Manual Adjust Mode Description

(1) Enter the manual adjust mode

Turn the power on by holding down TK and SK2 key simultaneously for 2 seconds, then the radio

enters manual adjust mode with red LED flashing twice.

(2) Channel number on the channel selector knob

Each channel on the channel selector knob is defined as a setting item. 25KHz bandwidth and low

frequency (F1) is set on the next channel each time the Channel Selector Knob is rotated.

(3) SK2 key

Used to set the frequency. 1 point tuning adjusts center frequency; 3 point tuning adjusts F1, F3,

F5; 5 point tuning adjusts F1-F5.

The frequency toggles from low frequency to high frequency. Green LED flashes once when F1 is

selected.