User's Manual

TC-700 Disassembly and Assembly for Repair

Disassembly and Assembly for Repair

1. Remove the case assembly from the chassis (as shown in Fig. 1)

1. Remove the volume knob and channel knob①.

2. Remove the two screws ②.

3. Lift the both sides of chassis from the case assembly ③.

Fig. 1

2. Remove the speaker (as shown in Fig. 2)

1. Remove the three screws on the fixing ring of the speaker ④ and take out the fixing ring ⑤.

Note: be careful not to snap the speaker’s lead wire.

2. Take out the speaker and water-proof gasket ⑥.

Fig. 2

3. Removing the Tx-Rx unit from the chassis (as shown in Fig. 3)

1. Loosen the nut on channel switch ⑦ and that on volume switch ⑧, and remove earphone

holder ⑨.

2. Remove

the screw ⑩ on the PTT key board.

3. Remove the ten screws ⑾ fixing the control board.

4. Remove the solder of the antenna terminal with a soldering iron ⑿.