User's Manual

7
Please follow these steps:
1. Plug the power cable into the adapter.
2. Plug the DC connector of the adapter into the DC socket on the back of the charger.
3. Place the radio with the battery attached, or the battery alone, in the charger.
4. Plug the AC connector of the adapter into the AC outlet socket.
5. Make sure the battery is in well contact with the charging terminals, the charging
process initiates when the red LED lights.
6. The greed LED lights about 3 hours later indicating the battery is fully charged. Then
remove the radio with the battery attached or the battery alone from the charger.
Note:
a) It is normal that the LED flashes before placing the battery into the charger.
b) Do not place another battery into the charger until the charger LED is stabilized.
c) After the battery is placed properly, the LED solidly glows red indicating the
battery is charging, or flashes indicating the battery is damaged or the ambient
temperature is over high/low.
Troubleshooting (intelligent rapid-rate charger only):
When troubleshooting, always observe the color of the LED:
No LED Indication?
1. Make sure that the power cord is plugged into an appropriate AC outlet.
Red LED flashes rapidly (0.2s on/0.2s off)?