User's Manual

13
Table below explains the functions of the LEDs and beeps.
Source radio: Turn the source radio on while
holding down the PTT and SK2.
Slave radio: Rotate the On-Off/Volume
Control knob clockwise to turn the slave
radio on.
The orange LED flashes
twice.
Source radio (power on the slave radio and
connect the cloning cable, then press the
PTT of source radio to initiate cloning.)
1) LED solidly glows red
when cloning progress;
2) LED goes out when
cloning is finished;
3) LED flashes red when
cloning fails.
Wired
Clone
Slave radio 1) LED solidly glows green
when cloning progress;
2) LED goes out when
cloning is finished.
Turn on both the source radio and slave
radio while holding down the PTT and SK1.
Both radios are required to be on the same
channel for cloning.
The orange LED flashes
once.
Source radio (turn on both the source radio
and slave radio while holding down the PTT
and SK1, then press the PTT of source radio
while both radios are on the same channel to
initiate cloning.)
LED solidly glows red when
cloning progress.
Wireless
Clone
Slave radio 1) LED solidly glows green
when cloning progress;
2) LED flashes green and
radio sounds beep tone,
when cloning is finished;
3) LED flashes red when
cloning fails.