User's Manual

6
Consult the dealer or an experienced radio/TV technician for help.
FCC Licensing Requirements
Your radio must be properly licensed Federal Communications Commission prior to use.
Your HYT Wireless dealer can assist you in meeting these requirements. Your dealer will
program each radio with your authorized frequencies, signaling codes, etc., and will be
there to meet your communications needs as your system expands.
Caution:
Changes or modifications to this unit not expressly approved by the party responsible for
compliance will void the user’s authority to operate the equipment. Any change to the
equipment will void FCC grant.
FCC 15.19
This device complies with part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Industry Canada RSS-102 Exposure of Humans to RF Fields.
Precautions
• Only qualified technicians are allowed to maintain this product.
• Do not use the radio or charge a battery in explosive areas such as coal gas, dust,
steam, etc.
• Switch OFF the radio while refueling or parking at gas station.
• Do not modify or adjust this radio for any reason.
• Do not expose the radio to direct sunlight over a long time, nor place it close to heating
source.
• Do not place the radio in excessively dusty, humid areas, nor on unstable surfaces.
• The SAR measured values of this equipment are: of body-worn is 3.52 and face-held
is 2.29.
• Hold the radio in one to two inches (2.5 to 5 cm) away from your lips.
• If the ambient temperature is over-high to the degree that PCB board reaches 85℃
during transmitting process, the transmitting power of the radio will decrease.
Safety: It is important that the operator is aware of and understands hazards common to