User's Manual

Low Battery Warning

Low Battery Warning alerts you to recharge or replace the battery. When the battery

voltage becomes low, radio LED will flash red and three Beeps sound every 30 seconds,

indicating to recharge or replace the battery with a new one.

Safety Check

When receiving a safety check call, the radio will emit an alert tone in preprogrammed

time. Press any key to respond and cancel the alert, otherwise, the radio will automatically

enter emergency mode.

CTCSS/DCS Signalling

CTCSS/DCS may have been programmed on a channel to ignore unwanted calls from

other parties on the same channel. When CTCSS/DCS signalling is set, the squelch will

be opened only when signals containing the matching tone or code are received. This

allows you to ignore (not hear) these calls. Likewise, your signals will be received only by

parties using the same CTCSS/DCS signalling.

Although it may seem like you have a private channel while using CTCSS/DCS signalling,

other parties can still hear your calls if they use the same tone or code.

DTMF Signalling

DTMF Signalling is enabled/disabled by your dealer. When DTMF signaling is

programmed on a channel, press the programmable key (Call 1, Call 2) to transmit DTMF

code.

●LED glows red during transmission and goes out when transmission ends.

2-Tone/5-Tone/HDC2400

Signalling

2-Tone/5-Tone/HDC2400

signalling is enabled/disabled by your dealer. When 2-Tone/

5-Tone/HDC2400

signalling is programmed on a channel, press the programmable key

(Call 1, Call 2) to transmit 2-Tone/5-Tone/HDC2400

signal.

When 2-Tone/5-Tone/HDC2400

is set on a channel, the preset functions will be