User's Manual

15
clockwise to turn off the radio. When the radio is on, turn the knob to adjust the
volume.
(10) LED Indicator
Radio status is indicated by LED state/color or alert tone.
Source radio is turned on
while holding down
[PTT+SK2]; directly turn the
target radio on.
LED flashes orange twice
after entering User Wired
Clone Mode.
Source radio (after the
starting of the target radio
and the installation of the
cloning cable, push PPT on
the source radio to begin
cloning.)
LED solidly glows red during
cloning;
LED goes out in case of
successful cloning;
Flash red once every second
in case of cloning failure;
User Wired Clone
Target radio
Solidly glow green during
cloning;
Go out when cloning is
completed;
Adjust the source and target
radios to the same channel.
Turn the source and target
radios on while holding down
[ PTT+SK1] .
Flash orange once after
entering Wireless Clone
Mode.
Source radio (After the
source and target radios are
turned on and stay in the
same channel, hold down
PPT on the source radio to
begin cloning.)
Solidly glow red during
cloning.
Wireless Clone
Target radio
Solidly glow green during
cloning;
LED flashes green and two
Beeps are heard in case of
successful cloning;
Flash red in case of cloning
failure;
Power on in User Mode Flash green once
Low Battery Alert
Solidly glow red; three Beeps
every 30s;