User's Manual

Monitor/Squelch Off

● Monitor

Toggle

Press the preprogrammed Monitor Toggle key to enable the signaling squelch feature;

press it again to exit.

● Monitor Momentary

Press and hold the

Monitor Momentary key to enable the signaling squelch feature;

release it to exit.

● Squelch Off

Press the preprogrammed Squelch Off key to activate the noise squelch feature; press

it again to exit.

● Squelch Off Momentary

Press and hold the Squelch Off Momentary key to activate the noise squelch feature;

release it to exit.

Scan

Press the preprogrammed Scan key, scan starts from the current channel and goes

through the scan list. Red LED flashes in scan mode and solidly glows when a signal is

received on a channel and signaling matches. Press the key again to exit.

● Nuisance Temporary Delete

When scan stops on a channel, press the preprogrammed Nuisance Temporary

Delete key to temporarily remove the channel from the scan list.

■ You cannot delete the priority channel, if one has been set.

■ You cannot delete a channel if there will be less than 2 channels available for

scanning.

■ Exit from scan mode or turn on the radio again, the deleted channel will return

to the scan list.

● Nuisance Delete

Press the preprogrammed Nuisance Delete key to permanently remove the channel

from the scan list. The deleted channel can’t return to the scan list even though the