User's Manual

Accessory Installation

Attaching the Battery

1. Push the battery along the guide on back of the radio until the battery latch at the

bottom of the radio locks

Removing the Battery

1. Turn off the radio.

2. Pull back the battery latch.

3. Slide the battery away from the radio.

Attaching the Antenna

1. Screw the antenna into the connector on the top of radio by holding the antenna at its

base.

2. Turn the antenna clockwise to fasten it.

Removing the Antenna

1. Turn the antenna counter-clockwise until you can remove it.

Attaching the Belt Clip

1. Align the screw eyelets of belt clip holder with those of radio chassis.

2. Use the supplied screws to lock it.

Removing the Battery Clip

1. Loosen the screw to remove the belt clip.

Attaching Remote Earphone/Microphone

1. Unclose the cover of the earphone/microphone jack (no need to remove it);

2. Insert the earphone/microphone plug into the jack.

Note: The radio is not fully water resistant while using remote earphone/microphone.