Service Manual
7
Transmit
LED glows red.
When transmission times out, “BEEP” tone sounds
continuously.
TOT pre-alert: “BEEP” tone sounds once.
Receive When a carrier is received, LED glows green.
Scan
When detecting, LED flashes green every second.
Scan start tone (programmable by your dealer): “BEEP”
tone sounds once.
Scan stop tone (programmable by your dealer): “BEEP”
tone sounds once.
Priority channel scan tone (programmable by your
deader): If the radio stays on a priority channel during
receiving, “BEEP” tone sounds once.
Programming
Reading: LED flashes red.
Writing: LED flashed green.
Power Adjust
When switching from high power to low power, a
descending tone sounds.
When switching from low power to high power, an
ascending tone sounds.
VOX
When enabling the VOX function, an ascending tone
sounds.
When disabling the VOX function, a descending tone
sounds.
Channel Selector Knob
Rotate the knob to select from channels 1 to 16.
On-Off/Volume Control Knob
Rotate the knob clockwise to turn the radio on, while rotate the knob fully counter-clockwise until a
“click” is heard to turn the radio off.