Service Manual
6
SK1
Side key 1, programmable. Your dealer can program the key with a function via the programming
software.
SK2
Side key 2, programmable. Your dealer can program the key with a function via the programming
software.
LED
LED statuses and alert tones:
Power on the source
radio while holding down
the SK2 key.
Power on the slave
radio directly.
LED flashes orange once.
Source radio (After the
slave radio is powered
on and the cloning cable
is connected, press SK2
on the source radio to
start cloning)
When cloning, LED flashes red.
When completed, red LED goes out.
When failed, red LED goes out.
User
Wired
Clone
Slave radio
When cloning, LED flashes green.
When completed, green LED goes out.
Powering On in User Mode
The power-on alert tone sounds when the radio is
powered on.
When the current channel is idle, “BEEP” tone sounds
continuously.
Low Battery Power Alert
LED flashes red and a descending tone sounds every
ten seconds.