User's Manual

18
priority channel periodically while stopping on a non-priority channel. When there is any
activity on the priority channel, the radio will automatically switch to the priority channel for
communications.
■ Scan Revert Channel
If the radio is scanning and you press the [PTT] key, it will transmit on the preprogrammed
revert channel. The revert channel can be programmed by your dealer.
Busy Channel Lockout
If the Busy Channel Lockout feature is enabled by your dealer, it will prevent you from
talking on a channel that is already in use. When you press the [PTT] key, the radio will
sound a beep tone and will not transmit. Release the [PTT] key to stop the beep tone.
Wait until the channel is not in use before you again try to transmit.
Troubleshooting Guide
Trouble Solution
No power
●Battery is low. Recharge or replace the battery.
●The battery may not be properly installed. Remove
the battery and attach it again.
Power doesn't last long even if
fully charged
●Battery has lost its capacity, replace it with a new
one.
Can't talk to or hear group
members
●Make sure you are using the same frequency, same
CTCSS/DCS and same 2-Tone as your group
members.
● Your group members may be out of the
communication range.
Other voice (non-group
members) are present on the
channel
●Change CTCSS/DCS tone. Make sure your group
members all change to the same tone.