User's Manual

15
High/Low Power
This feature is enabled/disabled by your dealer. In receive mode, press the
preprogrammed High/Low Power key
to toggle between high and low power. Three beeps
alternating from high tone to low tone indicate that the transmit power is switched from
high to low; and three beeps alternating from low tone to high tone indicate that the
transmit power is switched from low to high.
Compatible Channel Bandwidth
The dealer can select wideband or narrowband channel bandwidth via PC programming
software.
2-Tone Encode & Decode
When 2-Tone signalling is set, press the function key while holding down the [PTT] key to
transmit the 2-Tone code.
2-Tone decode and CTCSS/DCS decode can be set to one of
the two signalling logics (“AND”/ “OR”) to achieve Selective Call feature (set by your
dealer). Parameter settings are made through PC programming software.
DTMF ANI
This feature is enabled/disabled by your dealer. DTMF ANI is encoded by PTT ID. Each
radio is assigned with one ANI code consisting of
BOT ID (Beginning of Transmission) and
EOT ID (End of Transmission). Each channel can be programmed by PC programming
software to transmit/not transmit ANI code in transmit mode.
CTCSS/DCS Signalling
CTCSS/DCS may have been programmed on a channel to ignore unwanted calls from
other parties on the same channel. When CTCSS/DCS signaling is set,
user will receive
the calls on the same channel only when the received signals contain the matching
CTCSS/DCS code; otherwise, the user receives all the calls on the same channel within
communication range.