User's Manual

to perform auto-detection until it operates normally. During the detection process, do

not handle the earpiece; otherwise, it may malfunction due to detection errors.

3. If the earpiece functions abnormally, please pull and plug it again as instructed above.

4. You may select VOX levels according to the operating environment. Too much noise

and too high VOX level may cause the radio to transmit continuously.

5. Use only the VOX earpiece specified by HYT, and properly plug it into the jack;

otherwise, the VOX function may not work.

Troubleshooting

Symptom Solution

Cannot power on the radio.

z The battery may have run out. Please

recharge the battery or replace it with a new

one.

z The battery may have been improperly

installed. Please remove the battery and

insert it again.

The fully charged battery runs down

quickly.

z The battery may have worn out. Please

replace it ASAP.

z The battery is not fully charged. Make sure

the battery is removed only after the

Charge Indicator of the radio or the charger

LED glows green.

Cannot communicate with group

members.

z Make sure you are on the same channel -

check whether the Channel Lock function is

enabled or other channels are locked by

error. When this function is enabled, current

locked channel can not switch even if you

rotate the Channel Selector knob.

z Make sure that radios in your group use the

same CTCSS/CDCSS signaling and

operate on the same channel.