User manual

Shenzhen Hyking Industrial Co., Ltd HK-DVR User Manual
 Down: roll down the rotating platform;
 Left: roll the rotating platform to left;
 Right: roll the rotating platform to right;
 Upper left: roll the rotating platform to upper left.
 Upper right: roll the rotating platform to upper right;
 Lower left: roll the rotating platform to lower left;
 Lower right: roll the rotating platform to lower right;
3. Control the lens
 Scale: press the left button to scale-up, and right button to scale-down, release to close;
 Zoom: press the left button to zoom in, and the right button to zoom out, release to close;
 Aperture: press the left to enlarge, and the right button to reduce, release to close;
 Rain brush: click to enable or disable the rain brush of host;
 Auto: click to enable or disable the auto status of host;
 Light: click to enable or disable the light of host.
Enable and Disable the Alert
The operation of enables and disables the alert only to be handled by single channel. Select the
channel to be operated and click the indicator light in the channel selecting section. Then the
indicator light will switch as
and the alert detection is activated in this channel. Click the button
again to switch back to
and halt the detection. While the alert activated, if the system detect the
alert signal, the indicator light of alert for this channel will turn into
, then the system will start the
alert recording and send out alarm sound (if this option has been checked). After the alert occurred,
with the right click mouse on the corresponding red indicator light, the map that indicate the location
of the alert occurred will pop-up. On the map the alert point will display as red. With left click mouse
on the corresponding red alert indicator light to shutdown the alert, and the indicator light will switch
back to
.
Setting of the Alert Section
If the user does not want to draw the alert section manually, then the system will include the whole
screen as an alert section. The user can set multiple alert sections on each preview image. The process
described as below: press the Ctrl key and draw a square on the needed image of channel with the left
button of mouse. If you want to remove an alert section, left click mouse on this section and a dialog
box that shown as below will pop-up. Then select the needed option in the dialog box. Here the Ctrl
key is important for the operations. While press the Ctrl key, all the squares of alert section for all
channels will display (if existed); while release the Ctrl key, all the squares will hide.
Web: www.kingcctv.com
E-mail: [e-mail] Page 24 of 24