User manual

Shenzhen Hyking Industrial Co., Ltd HK-DVR User Manual
started, merely to set an IP address randomly while the user needs the system to dial a telephone
number, such as stationary phone, mobile phone or Pager.
3. Alert type
Sensor detection: Select this option to start the alert of sensor detection. While detect the signal
of sensor, the system will activate the hardware alert logic immediately
Software detection: means the mobile detection, while detect the mobile signal that reached the
pre-setting sensitivity, the system will activate the mobile alert immediately.
None: Do not start any alert, and all the subsidiary parameters will be unavailable.
The definition of subsidiary parameters that specified by the alert type is listed as below:
 Announce all the clients whom monitoring this channel while the alert triggering: the host
will broadcast the alert signal if this option selected, the corresponding clients will response
with detailed character information or alert map, etc.
 Start the alert recording while alert triggering: if this option not checked, only the interface
display and alert output will be processed while the alert signal was received. The recording
will be unavailable. If this option checked, the recording will activate immediately while the
alert signal was received, and keep the working status after received the last alert signal
during the delay time that the user has set. As the figure above, the delay time is 50 seconds.
 Start the preview for recording: if this option checked, each time when the mobile alert
received, the system will automatically save a period of recording before the alert signal was
received. The length of recording time is less than 2 minutes.
 Sensitivity: the value of mobile detecting sensitivity is between 1 and 100. Note: the
sensitivity will reduce by the increasing of the value. This option is only available to the
detection of software.
 Activate the sound of alert: Here the setting of this function is same as the detection of lost
video.
 (Second) Alert duration: Indicate the durative time value of the corresponding alert sound
while the system received the alert signal each time.
 Map to the alert box output: start the alert box output while received the alert signal, using
for alert by the detection of software.
4. Map
Click the [Map..] button at the upper right corner, the [Map Setting of Alert] dialog box will
pop-up. In this dialog box the user can add, modify, save, and delete the map and alert point,
which is shown as below.
Web: www.kingcctv.com
E-mail: [e-mail] Page 14 of 14